Windshield Washer Pump: Service and Repair

WINDSHIELD WASHER PUMP AND RESERVOIR

Washer System:

Removal and Installation
1. Remove the RF wheel and tire assembly.
2. Remove the splash shield pin-type retainer.
3. Remove the 3 screws and the splash shield.

4. NOTE: Windshield washer fluid should be collected in a container after the windshield washer hose is disconnected.

Remove the windshield washer reservoir and pump supply line.

5. Disconnect the windshield washer pump electrical connector.
6. Remove the 3 bolts and the windshield washer reservoir.
- To install, tighten to 6 Nm (53 lb-in).

7. Remove the windshield washer pump.
8. To install, reverse the removal procedure.