Clutch: Adjustments

Description:

1. Disconnect return spring at clutch fork.

2. Rotate clutch lever and shaft assembly until pedal is against rubber bumper on dash brace.

3. Push outer end of clutch fork rearward until throwout bearing lightly contacts pressure plate fingers.

4. Install push rod in gauge hole and increase length until all lash is removed.

5. Remove swivel or rod from gauge hole and insert into lower hole on lever. Install retainer and tighten lock nut using care not to change rod length.

6. Install return spring and check clutch pedal free travel. Free travel should be 3/4 to 1 5/16 in.