Service Procedure

Installation of Moisture Deflector Shield:

Installation of Moisture Deflector Shield Fig. #1.

1. Remove cap and retainer from fluid reservoir.

2. With notch of deflector hole positioned toward rear of vehicle, tuck deflector under the lip of the fender as shown in illustration.

NOTE: Failure to install deflector as instructed will not provide adequate moisture protection for pump.

3. Slip hole in deflector over neck of reservoir, then reinstall retainer and cap.

Replacement of Washer Pump:

Replacement of Washer Pump Fig. #2.

Remove or Disconnect

1. Battery ground cable from the battery.
2. Two reservoir retaining screws.
3. Reservoir.
4. Electrical connector at the motor.
5. Fluid tube at the motor.
6. Motor from the reservoir.

Install or Connect

1. Motor to the reservoir.
2. Fluid tube at the motor.
3. Electrical connector at the motor.
4. Reservoir.
5. Two reservoir retaining screws.
6. Battery ground cable to the battery.