Rear Inner Headliner Roof Molding - Sagging

CHEVROLET NUMBER 87-T-41

SECTION: 10 - Body Section

DATE: January, 1987

SUBJECT: REAR INNER HEADLINER ROOF MOLDING

MODELS: 1979-1984 C/K, 1985-1986 K, AND 1987 V JIMMY/BLAZER

During high in-vehicle temperatures, the rear headliner roof molding on the subject models may warp or sag. If this condition occurs, a new molding, P/N 15554978, has been released for service. This new molding has four additional screws retaining the molding to the roof inner panel.

Figure No. 1 - Replacing Rear Headliner Roof Molding:

To install, place the new molding into position and attach at each end using existing holes (See Figure No. 1). Drill four 1/8" holes into the roof

inner panel that correspond to the holes in the new molding. Attach using screws, P/N 11504659.

Beginning with the following VIN breakpoints, the new molding was incorporated into production.

Chevrolet - HF187901
GMC - HF527088