Valve Body & Associated Parts

Refer to the "Service Bulletins" section prior to performing the following procedure.

Fig. 10, 1-2 & 3-4 accumulator assembly. 1986 Models:

1. Install 3-4 accumulator pin into case, Fig. 10, then the 3-4 accumulator piston seal onto the 3-4 accumulator piston.
2. Install 3-4 accumulator piston onto the pin. End with three legs should face valve body.

Fig. 94, 1-2 & 3-4 accumulator spring chart. 1986:

3. Install 3-4 accumulator piston spring. Refer to Fig. 94.
4. Install governor and converter clutch oil screens.

Fig. 15, Case check balls & filters. 1986 Models:

5. Install check balls in case as shown in Fig. 15, then tool No. J- 25025-5 into the case.
6. Install spacer plate to case gasket. Gasket is identified by a "C" marking.
7. Install spacer plate, then the valve body to spacer plate gasket. Gasket is identified by a "V" marking.