Ignition Lock Cylinder

Fig. 1 Ignition lock removal & installation:

1. Disconnect battery ground cable.
2. Remove steering wheel. Refer to ``Horn Sounder & Steering Wheel, Replace.''
3. Remove turn signal switch. Refer to ``Turn Signal Switch, Replace.''
4. Place ignition switch in ``Run'' position, then remove lock cylinder retaining screw and lock cylinder.
5. To install, rotate lock cylinder to stop while holding housing, Fig. 1. Align cylinder key with keyway in housing, then push lock cylinder assembly into housing until fully seated.
6. Install lock cylinder retaining screw, turn signal switch and steering wheel.