M/T - Clutch Chatter/Shudder On Launch

91chevy20

GMC NUMBER: 91-7C-104(A)

GROUP: 7C Clutch

DATE: July, 1991

CORPORATE
NUMBER: 167303


SUBJECT: CLUTCH CHATTER / SHUDDER ON LAUNCH

MODELS: 1988-91 C2, C3, K2, AND K3 TRUCKS EQUIPPED WITH 7.4L ENGINES AND 4 SPEED MANUAL TRANSMISSIONS

THIS BULLETIN CANCELS AND REPLACES GMC TRUCK SERVICE BULLETIN 91-7C-104, DATED JUNE 1991 TO UPDATE THE LABOR TIME. ALL COPIES OF 91-7C-104 SHOULD BE DISCARDED.


Some 1988-91 C2, C3, K2, AND K3 trucks equipped with 7.4L engines with 4 speed manual transmissions may experience a condition of chatter or shudder on launch.

Revised clutch discs and matching pressure plates have been released for these vehicles and are available through GMSPO. The clutch discs feature a revised facing material which will provide smoother engagement and increased wear resistance. These revised discs can be identified by the name stamp Valeo while the previous discs were stamped Borg Warner. The pressure plates have been revised to work with the discs and must be replaced at the same time. The revised pressure plates will be marked with the name stamp Luk while the previous pressure plate may be marked with the name stamp Luk or Borg Warner.

The installation of these parts will provide significant improvement in the involved vehicles.

VEHICLES INVOLVED:
Some 1988-91 C2, C3, K2, AND K3 trucks equipped with 7.4L engines and 4 speed transmissions built prior to the following VIN breakpoints may exhibit the subject condition:

Plant GMC Chevrolet
Fort Wayne (Z) No Vehicles No Vehicles
Involved Involved
Oshawa (1) M1529314 M1185747
Pontiac (E) ME520659 ME162285


SERVICE PROCEDURE:
The pressure plate and clutch disc should be replaced at the same time as the parts have been designed to work together. Refer to section 7C of the appropriate service manual for clutch disc and pressure plate replacement procedure.

Important

Before removing the existing pressure plate, note the location of the paint dab on the pressure plate cover. This paint dab indicates the heavy side of the pressure plate assembly and is aligned with the light side of the engine at the assembly plant. The new pressure plate should be installed with paint dab in the same location to preserve the balance of the engine assembly.

SERVICE PARTS INFORMATION:

Pressure Clutch Disc
Engine Transmission Plate P/N P/N
7.4L 4 Speed 15679571 15679572

Parts are currently available from GMSPO.

WARRANTY INFORMATION:
For vehicles repaired under warranty use:
Labor Operation: K0800

Model Labor Time Add
C 2.2 -
K 3.0 0.3 hr. w/Skid Plate