Rear

Before removing the wiper motor from the rear glass, perform the following tests:

1. Disconnect the wiring harness and apply (+) 12V to terminal (C) of the wiper motor. Ground terminal (B) of the wiper motor. The wiper motor should run.

NOTE: Before performing test 2, be sure wiper is not in the park position.

2. Test for proper park operation by applying (+) 12V to terminal (A). Ground terminal (B). The wiper motor should go to the park position and shut off.

NOTE: If the wiper motor performs the above tests, the problem is in the wiring harness or the switch. If the motor is faulty, it must be replaced, no internal service parts are available.