Ignition Lock Cylinder

Fig. 1 Ignition Lock Replacement:

1. Disconnect battery ground cable.
2. Remove steering wheel. Refer to STEERING WHEEL & HORN SOUNDER.
3. Remove turn signal switch. Refer to BODY ELECTRICAL SAFETY AND ENTERTAINMENT/INSTRUMENT PANELS AND CLUSTERS/COMPONENT REPLACEMENT AND REPAIR PROCEDURES/TURN SIGNAL SWITCH.
4. Place ignition switch in ``Run'' position, then remove lock cylinder retaining screw and lock cylinder.
5. To install, rotate lock cylinder to stop while holding housing, Fig. 1. Align cylinder key with keyway in housing, then push lock cylinder assembly into housing until fully seated.
6. Install lock cylinder retaining screw, turn signal switch and steering wheel.