R/V Suburban

1. Disconnect the electrical connectors if vehicle is equipped with power seats.

2. Remove seat belt guide, if applicable.

3. Remove seat riser to floor retaining bolts (do not discard).

4. Remove seat. To provide support, lay seat on its side on a workbench or equivalent.





5. Remove seat back recliner retaining bolts (Figure 1, Item 2 - bolts will not be reused). Move seat back aside to gain access to the cloth/foam around the bolts.

6. Cut cloth/foam material away to allow the recliner mechanism to properly seat against the seat frame (Figure 1, Item 1).

7. Install new recliner bolts and torque to 20-35 N.m (14-26 lbs. ft.) (Figure 1, Item 2). New bolts are coated with a shiny finish to allow easy identification.

NOTICE:
WHEN REINSTALLING BOLTS, ALL CLOTH AND FOAM MUST BE CLEAR OF BOLT AREA.

8. Install seat using retaining bolts removed in Step 3 and torque bolts to 35 N.m (26 lbs. ft.). Verify retaining bolts are seated properly.

9. Reconnect electrical connectors if vehicle is equipped with power seat.

10. Install seat belt guide, if applicable.

11. Repeat procedure for passenger seat.

12. Install Campaign Identification Label.