Shaft Seal

Component View:

Compressor Shaft Seal:

Remove or Disconnect

Tools Required:
J 5403 External Snap Ring Pliers
J 34614 Shaft Seal Protector
J 23128-A Seal Remover and Installer
J 9553-01 O-Ring Seal Remover

1. Clutch plate and hub assembly (2).
- Install J 34614 over the threaded end of the shaft (20).

Removing Or Installing The Shaft Lip Seal Retaining Ring:

2. Shaft seal retainer ring (8) using J 5403.
- Clean the compressor neck area around the shaft (20), the exposed part of the shaft seal (9) and the O-ring seal groove.

Removing Or Installing Shaft Lip Seal:

3. Shaft lip seal (9) using J 23128-A.
- Insert J 23128-A into the shaft lip seal, tighten and remove lip seal.

Removing The Shaft Seal Seat 0-Ring:

4. O-ring seal (10) using J 9553-01.

Inspect
- Make sure the compressor neck area is clean.
- All parts. Replace as necessary.

Install or Connect

Tools Required:
J 33011 O-Ring Seal Installer
J 23128-A Seal Seat Remover and Installer
J 34614 Shaft Seal Protector
J 5403 External Snap Ring Pliers

- Dip the new O-ring seal in clean 525 viscosity refrigerant oil.
- J 34614 onto the shaft (20).

Installing The Seal Seat O-Ring:

1. O-ring seal using J 33011.
- Insert J 33011 into the compressor neck until the installer "bottoms."
- Lower the movable slide of J 33011, releasing the O-ring seal into the lower groove.
- Rotate J 33011 to seat the O-ring seal and remove J 33011.
2. Shaft lip seal using J 23128-A.
- Dip the shaft lip seal in clean 525 viscosity refrigerant oil and install shaft lip seal on J 23128-A.
- Bottom the shaft lip seal into the compressor neck area using J 23128-A.
- Release and remove J 23128-A.
3. Shaft seal retaining using J 5403.
- Install the flat side of the shaft seal retainer ring against the lip seal.
- Remove J 34614.

Important
- Leak test the compressor.

Clean
- Shaft (20) and inside the compressor neck area.

4. Clutch plate and hub assembly (2).