Interior - Electric Outside Rear View Mirror Wind Noise
BULLETIN NUMBER: 92-10-151SECTION: 10
NUMBER: 3
CORPORATE REFERENCE NUMBER: 261011
DATE: January 1993
SUBJECT:
ELECTRIC OUTSIDE REAR VIEW MIRROR WIND NOISE
MODELS:
1991-92 S/T VEHICLES WITH RPO D48
Owners of some 1991-92 S/T vehicles equipped with electric outside rear view mirrors may comment on excessive wind whistle.
This condition may occur if air flows behind the mirror assembly and through the door panel wiring harness access opening.
To correct this condition, it is necessary to install foam behind the mirror assembly.
SERVICE PROCEDURE
1. Remove the three mirror assembly mounting screws. Hold the mirror assembly away from the door without disconnecting the wiring harness.
2. Install urethane closed cell foam (procured locally) around the electric mirror wiring harness and in the door panel access opening to eliminate any void areas.
3. Reposition the mirror assembly on the door and install the three mounting screws. The screws must be installed in the sequence shown in Figure 1, location A first, then B and C.
WARRANTY INFORMATION
Labor Operation: T7616
Labor Time: 0.2 hr
Note:
Labor Operation is coded to base vehicle coverage in the warranty system.