B Pillar - Creaking Noise
91chevy12
GMC NUMBER: 91-10-69
GROUP: 10 Body Section
DATE: March, 1991
CORPORATE
NUMBER: 161501R
SUBJECT: CREAK/SQUEAK NOISE IN "B" PILLAR
MODEL: 1991 S/T 2 AND 4 DOOR UTILITY VEHICLES
Some 1991 S/T utility vehicles may experience a creak or squeak in the "B" pillar post that is located directly behind the front door. This condition is caused by movement between the floor of the cab and the number two body mount located directly under the "B" pillar and may occur on either or both sides of the vehicle. To correct the condition use the following procedure:
1. Remove the # 2 body mount bolt.
2. Raise the body off the mount to obtain clearance between the floor and the top of the body mount.
3. Cut a 4 inch x 4 inch square of 1/32" thick teflon (obtain locally) and drill a 5/8" hole through the center. Insert this between the floor pan and the body mount and lower the body.
4. Clean the body mount bolt and apply Loctite 242 thread locking compound (GM P/N (12345382) or equivalent to the body mount bolt and retorque to 70-80 N-m (52-59 lbs.ft.).
Notice: Concern exists that some insulating materials may compress over time resulting in a loss of torque to the body mount bolt. For this reason, teflon, 1/32 inch thick, and the thread locking compound on the bolt are being specified.
An alternative to preferred teflon material that can be found in most truck dealerships consists of using three washer pump shields P/N 22063244 referenced in GMC campaign bulletin 86-C-02. The part is also available through GMSPO. Using this method, cut three sheets to size and locate a 5/8 inch hole in the center of each sheet. Place the three sheets between the floor pan and the mount and lower the body on the mount. Clean the body mount bolt and apply thread locking compound as described above and retorque bolt to 70-80 N-m (52-59 lbs.ft.)
SERVICE PARTS INFORMATION
Part Number Description
12345382 or equivalent Loctite 242 thread
locking compound
22063244 or equivalent Washer pump shields
teflon material
Parts are currently available from GMSPO or may be obtained locally.
WARRANTY INFORMATION For vehicles repaired under warranty use:
Labor Operation: T7206
Labor Time: 0.4 hr. (right and/or left B pillar)
NOTE: Labor Operation is coded to base vehicle coverage in the warranty system.