Seat Belts - Child Restraint Tether Belt Location

GMC NO.: 93-U-019

BOOK NO.: X-9030, X-9130, X-9230, X-9330

SECTION: 10A2

CORP. NO.: 361006

DATE: July 1993

SUBJECT:
CHILD RESTRAINT TETHER BELT LOCATION

MODELS:
M/L

The following represents new information for CHILD RESTRAINT TETHER LOCATION in section 10A2 for 1990 - 1993 M/L Vans.

CHILD RESTRAINT TETHER BELT LOCATION-SECOND SEAT BUCKET (Extended Van)





Use Figure 1 to determine the location of the tether belt hole.

To install the anchor plate, cut the carpet or mat and the insulation so that the anchor plate sits on the floor panel sheet metal.

Drill a 10.0 mm (3/8 inch) hole in the floor pan at the proper location.

Install or Connect (Figure 1)

1. An M8 bolt or equivalent through the anchor plate and the floor pan.

2. A medium bodied sealer around the cleaned hole at the underside of the floor panel.

3. A 62 mm (2-7/16 inch) diameter by 3 mm (1/8 inch) flat washer.

4. Nut.

Tighten

^ Nut to 27 N-m (20 lbs.ft.)