Rear Suspension

Fig. 6 Rear Stabilizer Assembly:

1. Raise and support vehicle.
2. Remove the bolts and washers from the link brackets, Fig. 6.
3. Remove the nuts, washers and clamp from the anchor block studs. At this point, the stabilizer bar assembly will be clear from the vehicle. Proceed only if a new stabilizer bar will be installed.
4. Remove the insulator from the stabilizer bar.
5. Remove the upper link nuts, washers and bolts from the assembly.
6. Remove the link bracket from the link assembly.
7. Remove the link nuts, washers and bolts, then pry open lower link to obtain clearance from the link insulator.
8. Remove the link insulator from the stabilizer bar.
9. Reverse procedure to install, tighten to specifications.