Service Procedure

1. Disconnect negative battery cable.

2. Disconnect connectors from ECM.

3. Disconnect ECM mounting hardware.

4. Remove ECM from passenger compartment.








5. Remove ECM access cover (Figure 1).
6. Using two fingers, push both retaining clips back away from the MEM-CAL. At the same time, grasp the MEM-CAL at both ends and lift it up out of the socket. Do not remove the cover of the MEM-CAL. Use of unapproved MEM-CAL removal methods may cause damage to the MEM-CAL or socket (Figure 2).

7. Install new MEM-CAL in MEM-CAL socket.

Important

Press only on the ends of the MEM-CAL. Small notches in the MEM-CAL must be aligned with the small notches in the MEM-CAL socket. Press on the ends of the MEM-CAL, until the retaining clips snap into the ends of the MEM-CAL. Do not press on the middle of the MEM-CAL, only the ends.
8. Install the access cover on ECM.
9. Write the following on the white ECM bar code label.

MEM-CAL part number 16164052
10. Install the ECM in the passenger compartment.

Important





When installing the ECM into the passenger compartment position the wire out of the top (green) connector (see item 1 Figure 3) between the connector thumb latch and the tab on grey comb.

Place tape as shown (Item 2 Figure 3) to retain wire in this position during ECM installation.

To avoid interference, it will be necessary to move the cross body power door lock harness as shown prior to ECM installation (see Item 3 Figure 3).

11. Apply the supplied tamper proof sticker over the access cover of ECM.

Important

Record the new PAS ECM tamper resistant label registration number on the front of the repair order as part of the write up.

12. Install the connectors to ECM.

13. Install the "Campaign Identification Label".

14. Install the negative battery cable.