DTC 33
Manifold Absolute Pressure Sensor Circuit Code 33:
Manifold Absolute Pressure Sensor Circuit:
Circuit Description:
The Manifold Absolute Pressure (MAP) sensor responds to changes in manifold pressure (vacuum). The ECM receives this information as a signal voltage that will vary from about 1-1.5 volts at closed throttle (idle) to 4-4.6 volts at Wide Open Throttle (WOT) (low vacuum).
If the MAP sensor fails, the ECM will substitute a fixed MAP value and use the Throttle Position Sensor (TPS) to control fuel delivery.
Test Description:
Number(s) below refer to circled number(s) on the diagnostic chart.
1. This step will determine if Code 33 is the result of a hard failure or an intermittent condition. A Code 33 will set under the following conditions:
^ MAP signal voltage is too high (low vacuum).
^ TPS less than 4%.
^ These conditions exist longer than 5 seconds.
^ Engine misfire or a low unstable idle may set Code 33.
2. This step simulates conditions for a Code 34. If the ECM recognizes the change, the ECM and CKT 416 and CKT 432 are OK. If CKT 455/469 is open, there may also be a stored Code 23.
Diagnostic Aids:
With the ignition "ON" and the engine stopped, the manifold pressure is equal to atmospheric pressure and the signal voltage will be high. This information is used by the ECM as an indication of vehicle altitude. Comparison of this reading with a known good vehicle with the same sensor is a good way to check accuracy of a "suspect" sensor. Readings should be the same +/- .4 volt.
A Code 33 will result if CKT 455/469 is open or if CKT 432 is shorted to voltage or to CKT 416.
If Code 33 is intermittent, see Intermittents. - Intermittent Malfunctions
^ Check all connections.
^ Disconnect sensor from bracket and twist sensor connections. Output changes greater than .1 volt indicates a bad connector or connection. If OK, replace sensor.
NOTE: Make sure electrical connector remains securely fastened.
^ See Manifold Absolute Pressure (MAP) Output Check MAP Sensor Output Diagnosis for further diagnosis.