Headlamp Dimmer Switch: Service and Repair

Fig. 11 Ignition Switch In Lock Position:

1. Disarm airbag as directed in ``Airbag System Disarming,'' then lower the steering column as described under ``Steering Column, Replace.'' There is no need to remove the steering wheel. Be sure to properly support the column.

2. Put the ignition switch in the Lock position. If the lock cylinder was removed, the actuating rod to the switch should be pulled up until there is a definite stop, then moved down one detent. This is the Lock position Fig. 11.

3. Remove two ignition switch screws, then the switch assembly.

4. Reverse procedure to install. Enable airbag as directed in ``Airbag System Arming.''