Clearing Diagnostic Trouble Codes

Data Link Connector:

If the ANTILOCK indicator lamp is staying on, the DTCs can be cleared with the Tech 1 scan tool or by doing the following procedure. (An engine remote starter can be used in place of the jumper wire for this procedure).

1. Turn the ignition switch to the "ON" position.
2. Use a jumper wire to ground DLC terminal "H" to "A" for two seconds.
3. Remove the jumper wire for one second.
4. Repeat the grounding for two seconds.
5. An indication of success is when the ANTILOCK and BRAKE lamps light and then turn off.