Differential Carrier Righthand Output Shaft & Tube
FRONT DIFFERENTIAL CARRIER RIGHTHAND OUTPUT SHAFT AND TUBEFig. 14 Right Hand Output Shaft & Tube:
DISASSEMBLE
1. Remove output shaft from tube by tapping inside of flange with a rubber mallet, Fig. 14.
2. Pry tube seal from tube, then remove bearing from tube using tool J-29369-2.
3. Drive differential shift cable housing seal out of tube using a suitable punch.
ASSEMBLE
1. Install output shaft tube bearing using tool J-33844. When bearing is properly installed, the tool will be flush with tube.
2. Install tube seal using tool J-33893. Flange of seal must be flush with tube outer surface.
3. Install output shaft into tube by tapping flange with a rubber mallet.
4. Install differential shift cable housing seal using tool J-33799.