Control Module Replacement

Fuel Module (Located Above Blower Motor Assembly):

CAUTION:
- The ignition must be "OFF," when disconnecting or reconnecting the control module connector, to prevent internal damage to the control module.

- To prevent possible Electrostatic Discharge to the control module, DO NOT touch the connector pins or soldered components on the circuit boards.

NOTE: When replacing a production control module with a service controller, transfer the broadcast DTC and production control module part number to the controller label. DO NOT record information on the access cover.

REMOVAL:

- Disconnect the negative battery terminal.
- Remove glove box panel.
- Remove mounting brackets and/or retainers.
- Remove control module from tray.
- Disconnect control module harness connectors.
- Remove access cover and PROM.

INSTALLATION:

- Install PROM and access cover on to new control module.
- Install mounting brackets and module(s).
- Install control module into tray until clips lock.
- Install control module harness connectors.
- Install glove box panel.
- Connect the negative battery terminal.
- Perform functional check.