Dieseling/Run-On
DIESELING, RUN-ON
Definition: Engine continues to run after key is turned "OFF," but runs very roughly. If engine runs smoothly, check ignition switch and adjustment.
IMPORTANT PRELIMINARY CHECKS
Before using this section you should have performed the "On-Board Diagnostic System Check" - Powertrain/On-Board Diagnostic System Check and determined that:
1. The control module and MIL (Service Engine Soon) are operating correctly.
2. There are no diagnostic trouble codes stored, or there is a diagnostic code but no MIL (Service Engine Soon).
^ Several of the following symptom procedures call for a careful visual/physical check. The importance of visual/physical checks cannot be over stressed. because they can lead to correcting a problem without further checks and can save valuable time.
VISUAL / PHYSICAL CHECK
This check should include:
^ Control module grounds for being clean, tight, and in their proper location.
^ Vacuum hoses for splits, kinks and proper connections, as shown on "Vehicle Emission Control Information" label Check thoroughly for any type of leak or restriction.
^ Air leaks at all mounting areas of the intake manifold sealing surfaces.
^ Ignition wires for cracking, hardness, proper routing, or carbon tracking.
^ Wiring for proper connections, pinches, and cuts.
^ The following symptom charts contain groups of possible causes for each symptom and cover several engines. These procedures are not necessarily meant to be done in consecutive order. If Tech 1 scan tool readings do not indicate the problems, then proceed in a logical order, easiest to check or most likely cause first. To determine if a particular system or component is used on a specific vehicle, refer to the "Electronic/Powertrain Control Module (ECM/PCM)" Wiring Diagrams for application. Electronic/Powertrain Control Module (ECM/PCM)
FUEL SYSTEM
^ CHECK: Evaporative system and fuel tank venting.
^ CHECK: Fuel injector(s) for leakage. for TBI injector diagnosis, refer to "CHART A-3 TBI".
^ CHECK: Idle speed control actuator operation, (7.4L only). Idle Speed Control Actuator Check