Composite Headlamp Bulb Replacement
HEADLAMP BULB REPLACEMENTCAUTION: Halogen bulbs contain a gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments.
To help avoid personal injury:
^ Turn the lamp switch OFF and allow the bulb to cool before changing it.
^ Leave the switch OFF until the change is complete.
^ Always wear eye protection when changing a halogen bulb.
^ Handle the bulb only by its base. Avoid touching the glass.
^ Do not drop or scratch the bulb. Keep moisture away.
^ Place the used bulb in the new bulb's carton and dispose of it properly.
Remove or Disconnect
1. Battery (right composite headlamp only.
2. Air intake box (left composite headlamp only.
3. Grille.
4. Screw from engine side of radiator support.
5. Capsule to radiator support screws.
6. Headlamp and side marker lamp connectors.
7. Headlamp assembly from the vehicle.
8. Bulbs from the headlamp assembly.
NOTICE: Avoid touching the bulb or letting it come in contact with anything damp. Oil from your skin or moisture on the bulb can cause the bulb to explode when it is turned on. It either comes in contact with the bulb, clean it with alcohol or a suitable degreaser and wipe the bulb dry.
Install or Connect
1. Upper and lower bulbs to capsule (if removed).
2. Electrical connectors for headlamp and park lamps
3. Capsule to the vehicle with screws.
Tighten Headlamp capsule screws to 7 N.m (62 in. lbs.)
4. Grille.
5. Air intake box (if removed).
6. Battery (if removed).