Shift Lever

This article has been updated with TSB # 563201.

SHIFT LEVER REPLACEMENT

REMOVE OR DISCONNECT
1. Negative battery cable.
2. Disable the SIR system.
3. Roll seal back until torx head screw is exposed.
4. Torx head screw.
5. Shift lever.

INSTALL OR CONNECT
1. Shift lever.
2. Torx head screw.
^ Screw to 22 Nm (29 lbs. ft.).
3. Roll seal over torx head screw.
4. Negative battery cable.
5. Enable the SIR system.
6. After shift lever is installed check in all positions for positive engagement of shift gate.