Control Valve Assembly/Accumulator Housing

CONTROL VALVE ASSEMBLY/ACCUMULATOR HOUSING

Control Valve Assembly/Accumulator Housing:

Accumulator Housing Assembly:

Control Valve Assembly:

Torque Sequence And Guide Pin Location:

Fig. 11 Check Ball Location.:

Fig. 10 Control Valve Assembly:

Torque Sequence, Control Valve And Switch Assembly:

NOTICE: The use of a honing stone, fine sandpaper or crocus cloth is not recommended for servicing stuck valves. All valve lands have sharply machined comers that are necessary for cleaning the bore. If these corners are rounded, foreign material could wedge between the valve and the bore causing the valve to stick. If it is found necessary to clean a valve, micro fine lapping compound 900 grit (J 38459) or finer should be used. Too much lapping of the valve will cause excessive clearances and increase the chance of a valve not operating.


CLEAN
- Control valve assembly and accumulator housing (51) thoroughly in clean solvent.
- Air dry.