Fuses Powering Several Loads

1. Find the schematic in I/P Fuse Block/Relay Center Details for the fuse that has blown.
2. Open the first connector or switch leading from the fuse to each load.
3. Replace the fuse:
^ If the fuse blows, the short is in the wiring leading to the first connector or switch. Use a test lamp, meter, or short finder as described above.
^ If the fuse does not blow, go to the next step.
4. Close each connector or switch until the fuse blows to find which circuit the short is in. Connect test lamp, meter, or short finder at the connector to the suspect circuit (disconnected) rather than at the fuse terminals.