Distributor Ignition (DI) System

Distributor Ignition (DI) Timing Mark:

Powertrain Control Module (PCM):

Engine Firing Order:

WARNING: To prevent possible personal injury from a moving vehicle or operating engine do the following before performing the checks:

^ Engage the parking brake and block the wheels.
^ Place the transmission is neutral.

1. Refer to the important engine information label located in the engine compartment on the label.
2. Put the Ignition Control (IC) system in the bypass mode by disconnecting the "set timing" connector. This is a single wire sealed connector that has a tan with black stripe lead.

The location of the "set timing" connector with a Powertrain Control Module (PCM) controller is near the PCM connectors in the passenger compartment.

3. With the ignition switch "OFF," connect the pickup lead of the timing light to the number one spark plug. Use a jumper lead between the wire and plug or an inductive type pickup.

NOTE: DO NOT pierce the wire or attempt to insert a wire between the boot and the wire. Connect the timing light power leads according to manufacturer's instructions.

4. Start the engine, and aim the timing light at the timing mark. The line on the balancer or pulley will line up at the timing mark. The timing specification is 0° BTDC. If a change is necessary, loosen the distributor hold-down clamp bolt at the base of the distributor. While observing the mark with the timing light, slightly rotate the distributor until the line indicates the correct timing. Tighten the hold-down bolt, and recheck the timing.