With Powertrain Control Module (PCM)

Throttle Position (TP) Sensor Central MFI:

TP Sensor:

CAUTION: The Throttle Position (TP) sensor is an electrical component and must not be soaked in any liquid cleaner or solvent, as damage may result.

REMOVE OR DISCONNECT
1. Electrical connector releasing locking tab.
2. Two TP sensor attaching screw assemblies.
3. TP sensor from throttle body assembly.

INSTALL OR CONNECT
1. With throttle valve closed, install TP sensor on throttle shaft. Rotate counterclockwise, to align mounting holes.
2. Two TP sensor attaching screw assemblies.

Tighten
^ Screw assemblies to 2.0 Nm (18.0 lb. in.).

3. Electrical connector.

CAUTION:
The hardware used to attach the Throttle Position (TP) sensor is coated with thread-locking adhesive. If any these parts are removed for service, inspect the attaching screw threads. There should be enough thread-locking material (adhesive or compound) on the threads to ensure proper relocking. If not, clean the threads and apply Loctite 262, or equivalent, to the threads before reassembly. Replacement screws are included in the service screw assortment package. New attaching hardware is included in the service packages.