Turn Signal & Multifunction Switch

TURN SIGNAL & MULTI FUNCTION SWITCH



























^ Tools Required:
- J 41352 Modular Column Holding Fixture
- Or Equivalent

REMOVAL
Remove or disconnect the following:
1. Do steps 1 through 7, Refer to Upper/Lower Shroud Steering Column Lock CYL Set.
2. Two wire harness straps (22) from steering column wire harness.
3. Steering column bulkhead connector from vehicle wire harness.
4. Grey and black connectors of turn signal and multifunction switch (24) from column bulkhead connector.
5. Two pan head tapping screws (13).
6. Turn signal & multifunction switch assembly (24) from column.

INSTALLATION
Install or connect the following:
1. Turn signal & multifunction switch assembly (24) to column.
- With small blade screwdriver compress electrical contact and move multifunction switch (24) into position.
- Electrical contact must rest on cancelling cam assembly (6).
2. Two pan head tapping screws (13). Tighten (13) to 6.0 Nm (53 lb in).
3. Grey and black connectors of multifunction switch (24) to column bulkhead connector.
4. Steering column bulkhead connector to vehicle wire harness.
5. Two wire harness straps (22) to steering column wire harness.
6. Do steps 4 through 10, Refer to Upper/Lower Shroud Steering Column Lock CYL Set.