Ignition Lock Cylinder, Shrouds

LOWER SHROUD, STEERING COLUMN LOCK CYL SET, UPPER SHROUD, SHIFT LEVER SEAL with Column Shift c/s Only.

Fig.18 Exploded View Of Tilt Steering Column (Part 1 Of 2):

TOOLS REQUIRED:
^ J 41352 Modular Column Holding Fixture

REMOVE OR DISCONNECT
1. Negative (-) battery cable.
2. Disable the SIR system.

NOTICE: Once steering column is removed from vehicle, the column is extremely susceptible to damage.






3. Lower or remove steering column from vehicle.
^ Secure steering column to modular Column holding fixture J 41352.
^ Place holding fixture into vise.

INSPECT






^ Steering shaft assembly for accident damage.
4. Tilt lever.
5. Two pan head tapping screws (13) from lower shroud (28).
6. Lower shroud (28).
^ Tilt shroud (28) down and slide back to disengage locking tabs.
7. Two torx head screws (14) from upper shroud (10).






8. Lift upper shroud (10) to gain access to lock cylinder hole.
A. Hold key in "START" position.
B. Using 1/16 - inch allen wrench push on lock cylinder retaining pin.
C. Release key to "RUN" position and pull steering column lock cylinder set (17) from lock module assembly (15).
D. Remove upper shroud (10).
9. Shift lever.
10. Shift lever seal (16).
11. Shroud protector (27) from lower shroud (28).

INSTALL OR CONNECT

NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Shift lever seal (16).
2. Shift lever.
3. Shroud protector (27) to lower shroud (28).






4. Move shift lever seal (16) and multi-function lever seal to ease in installation of upper and lower shrouds.
5. Upper shroud (10) and steering column lock cylinder set (17).
A. Key installed in lock cylinder (17) and in "RUN" position.
B. Ensure sector in lock module assembly (15) is in "RUN" position.
C. Lock cylinder (17) to upper shroud (10).
D. Line up locking tab and positioning tab with slots in lock module assembly (15) and push cylinder (17) into position.
6. Two torx head screws (14) to upper shroud (10).

TIGHTEN
^ Screws (14) to 1.4 Nm (12 lb.in.).

7. Lower shroud (28).
^ Ensure that slots on lower shroud (28) engage with tabs on upper shroud (10).
^ Tilt lower shroud up and snap shrouds together.
8. Two pan head tapping screws (13) to lower shroud (28).

TIGHTEN
^ Screws (13) to 6.0 Nm (53 lb.in.).

9. Shift lever seal (16) and multi-function lever seal into position.
10. Tilt lever.
11. Raise or install steering column to vehicle.
12. If all service operations are completed, enable the SIR system.
13. Negative (-) battery cable.