Component Tests and General Diagnostics

The Vehicle Speed Sensor Buffer processes inputs from the Vehicle Speed Sensor (VSS) and outputs signals to the Speedometer, Powertrain Control Module (PCM), Cruise Control Module and the Antilock Brake Module.

The VSS is made up of a 40-tooth rotor and a coil mounted on the transmission. As each rotor tooth nears the coil, the coil produces an AC voltage pulse. Each revolution of the rotor produces 40 AC voltage pulses. As the vehicle speed increases, the number of AC voltage pulses per second increases.

The Vehicle Speed Sensor Buffer takes the A/C voltage from the VSS and converts it to four Solid-State switch outputs.

The Speedometer switch output opens and closes at the same rate as the VSS pulses. The PCM and Cruise Control switches open and close at half the rate of the VSS pulses. The Antilock Brake Output Switch opens and closes at a rate seven times the VSS pulses.

The Vehicle Speed Sensor Buffer is matched to the vehicle based on transmission, final drive ratio and tire size. It is important to ensure that the correct Vehicle Speed Sensor Buffer is installed in the vehicle if replacement is necessary.