60000 MI or 96000 KM
LubricateSteering and Suspension
Lubricate the front suspension, ball joints, kingpin bushings, steering linkage, transmission shift linkage, transfer case shift linkage, parking brake cable guides, rear driveline center splines, front axle propshaft splines and brake pedal springs. Kingpin and ball joint bushings should not be lubricated unless their temperature is -12 degrees C (10 degrees F) or higher or they could be damaged.
Inspect
Radiator Cooling Fan
If your engine has a thermostatically controlled cooling fan, inspect hoses and ducts for proper hook-up. Be sure the valve works properly.
Heat Shield, Exhaust
Inspect shields and underhood insulation For damage or looseness. Adjust or replace as required.
Fuel Tank
Inspect the fuel tanks, cap and lines for damage or leaks. Inspect the fuel cap gasket for any damage. Replace parts as needed.
Fluid - Differential
Inspect front/rear axle fluid level and add fluid as needed.
Exhaust Gas Recirculation
Evaporative Emissions System
Inspect all the fuel and vapor lines and the hoses for proper hook-up, routing and condition. Ensure that the purge valve works properly, if equipped. Replace the components as needed.
Drive Belt
Replace
Oil Filter, Engine
Or every 12 months, whichever occurs first.
Fuel Filter
Engine Oil
Or every 12 months, whichever occurs first.
Clean/Repack
Wheel Bearing
Clean and repack the front wheel bearings (or at each brake relining whichever occurs first).