Service Procedure

1. Place vehicle in park, set parking brake and turn engine to full lock position.





2. Locate accelerator cable between accelerator lever assembly and bulkhead under dash (Figure 1).

3. Measure minimum clearance between accelerator cable and dash mat.

4. If clearance of at least 12 mm (0.5 in.) exists between cable and dash insulator mat through entire range of pedal travel, proceed to step 7.

5. Inspect area under mat around location to insure no wiring was routed under this section.

6. Using a carpet knife or similar tool, carefully cut away a sufficient section of the dash mat to provide at least 12 mm (0.5 in.) clearance between pad and accelerator cable through entire range of motion.

7. Install Campaign Identification Label.