Hesitation, Sag, Stumble

Definition: The vehicle has a momentary lack of response when depressing the accelerator. The condition can occur at any vehicle speed. The condition is usually most severe when trying to make the vehicle move, as from a stop sign. The condition may cause the engine to stall if it's severe enough.

Preliminary Check
Refer to Important Preliminary Checks. Testing and Inspection

Fuel System Checks

^ Check the fuel pressure. Refer to Fuel System Diagnosis. System Diagnosis - Fuel System
^ Check the Throttle Position (TP) sensor for binding or sticking. Voltage should increase at a steady rate as the throttle moves toward Wide Open Throttle (WOT).
^ Check the Manifold Absolute Pressure (MAP) sensor response and accuracy. Refer to DTC P0106 MAP System Performance. P0106
^ Check for water contamination in the fuel. Refer to Alcohol/Contaminants-in-Fuel Testing Procedure.
^ Check the Canister Purge system for proper operation. Refer to EVAP Control System Diagnosis. System Diagnosis - EVAP Control
^ Perform the fuel injector coil test. Refer to Fuel Injector Coil Test. Fuel Injector Coil Test
^ Perform the fuel injector balance test. Refer to Fuel Injector Balance Test. Fuel Injector Balance Test
^ Check for low fuel pressure after a cold start or during a moderate or full throttle acceleration. If the fuel pressure drops below specification, there is possibly a faulty fuel pump or a restriction in the fuel system.

Ignition System Checks

^ Check for faulty spark plug wires.
^ Check for fouled spark plugs.
^ Check for an open ignition system ground. Refer to Enhanced Ignition System. System Check - Enhanced Ignition System

Additional Checks

^ Check the Service Bulletins for PROM updates.
^ Check the generator output voltage. Refer to Engine electrical.
^ Check the EGR Valve operation. Refer to EGR System Diagnosis. System Diagnosis - EGR