Ignition Switch

Ignition switch position:

1. Disconnect battery ground cable.
2. Lower steering column. On some models, it may be necessary to remove the upper column mounting bracket if it hinders servicing of switch. Use extreme care when lowering steering column to prevent damage to column assembly. Only lower steering column a sufficient distance to perform ignition switch service.
3. Rotate ignition lock to ``Off'' locked position.
4. If lock cylinder has been removed, pull switch actuator rod up to stop, then push rod down to first detent as shown, Fig. 6.
5. Remove column mounted dimmer switch, if equipped, then remove switch retaining screws and switch.
6. Reverse procedure to install, noting the following:
a. Place gear shift lever in neutral.
b. Place lock cylinder and switch in positions noted in steps 3 and 4.
c. Fit actuator rod into hole in switch slider and secure switch with retaining screws, ensuring switch does not move out of detent.
d. Install and adjust dimmer switch, if equipped.
e. Torque retaining screws to 35 lb in, then check switch operation.