Rear Housing Assembly

- Tools Required:
- J 36190 Drive Handle
- J 36503 Output Shaft Oil Seal Installer
- J 36511 Oil Fill and Drain Plug Hex Bit (17 mm)
- J 36506 Fifth and Reverse Detent Bushing Remover/Installer

ASSEMBLE





1. Rear housing shift shaft bearing using J 36506 and J 36190.
A. Install bearing into bore so that the writing on bearing lip faces down.
B. Install flush.
2. Bearing assembly using brass drift.
- Output shaft bearing retainer.
- Three bolts. Apply Threadlocker or equivalent to the threads.

Tighten
- Bolts to 22 N.m (16 lb. ft.).

3. Two dowel pins.
- Drive until flush.
4. Oil drain plug into rear transmission case using J 36511.
- Apply pipe sealant with Teflon(tm) or equivalent to the threads.

Tighten
- Oil drain plug to 40 N.m (30 lb. ft.).