Replacement

REMOVAL





1. Remove the oil pan.





2. Remove the oil pump from the crankshaft rear main bearing cap.
3. Remove the oil pump and the hex drive.
4. Inspect the following parts:
- The oil pump pick up tube and screen for damage
- The oil pump hex drive retainer for cracks

INSTALLATION
1. Install the oil pump and the extension shah to the engine.
2. Align the extension shaft hex with the drive hex on the oil pump drive. The oil pump should push easily into place.
3. Install the oil pump and the bolt to the crankshaft rear bearing cap.
- Tighten the bolt to 90 Nm (65 ft. lbs.).
4. Install the oil pan.
- Tighten ail the oil pan bolts, except the rear two bolts, to 10 Nm (89 inch lbs.).
- Tighten the rear two oil pan bolts to 23 Nm (17 ft. lbs.).