Shift Lever Seal Replacement

REMOVAL
Remove or disconnect the following:
1. TORX head screws from lower column cover. Do not remove cover, let the lower column cover pivot on upper column cover.
2. Roll seal back until TORX head screw is exposed.
3. TORX head screw from shift lever.
4. Shift lever.
5. Shift lever seal.

INSTALLATION
Install or connect the following:
1. Shift lever seal.
2. Shift lever.
3. TORX head screw to shift lever. Tighten to 22 Nm (16 lb ft).
4. Roll seal up lever until TORX head screw is covered.
5. TORX head screws to lower column cover. Tighten to 6 Nm (53 lb in).