Low and Reverse Band/Thrust Washer Installation

- Tool Required:
- J 36850 TRANSJEL (TM)
- Or Equivalent

Important: During the following installation procedure, the smooth side of the output shaft selective thrust washer (674) faces up.





1. Install the output shaft selective thrust washer (674) as determined by the rear end play measurement during disassembly.
2. Retain with J 36850 or equivalent.

Important: During the following installation procedure, align the low and reverse band tab with the servo pin hole.

3. Install the low and reverse band (657).





4. Install the center support spacer (643) into the groove above the low and reverse band (657). The spacer opening should be placed at the nine o'clock position.