Resume/Accel "R/A" Switch

The "RESUME/ACCEL" switch controls three functions.
^ The Resume Function -If the cruise system has been disengaged by depressing the brake pedal, it may be reactivated by momentarily holding the "RESUME/ACCEL" switch. This will cause the vehicle to accelerate to the previously set speed and cruise at that speed. The resume function will not work if the cruise "ON/OFF" switch or the ignition switch has been cycled since the last time cruise was active or the vehicle speed is below the low speed lockout 40 km/h (25 mph).
^ The Accelerate Function -By sliding the "RESUME/ACCEL" switch and holding it, the vehicle will accelerate until the switch is released. The cruise "ON/OFF" switch must be on and the vehicle speed must be above the low speed lockout 40 km/h (25 mph) for this function to operate.
^ The "Tap Up" Function -For this function to operate, the cruise must be engaged and operating. "Tapping up" means quickly pressing the slide switch toward the "R/A" position and quickly releasing it, or "tapping" the lever
Do not hold the lever in the "R/A" position or the system will revert to the "Accel" mode. to the "Accel" mode. "Tap up" is a function in which cruise speed can be increased by 1.6 km/h (1 mph) increments (one tap=1 mph increase). The system cannot "tap up" beyond 201 km/h (125 mph).