Replacement, Engine Overhaul

REMOVAL
1. Remove the crankshaft oil deflector nuts (6) and deflector (2).
2. Remove the bolt (1) that attaches the oil pump to the rear crankshaft bearing cap.
3. Remove the oil pump (3), the driveshaft (5), and the retainer (4).

INSTALLATION
1. Assemble the oil pump (3), driveshaft (5), and retainer (4).
2. Install the oil pump (3).
3. Align the slot in the end of the driveshaft (5) with the drive tang on the distributor shaft.
4. Install the bolt (1) attaching the oil pump to the rear crankshaft bearing cap.
5. Install the crankshaft oil deflector (2) and nuts (6)
- Tighten the oil pump bolt to 90 Nm (66 ft. lbs.).
- Tighten the crankshaft oil deflector nuts to 36 Nm (27 ft. lbs.).