3500 Except C3500 HD

FRONT HUB BOLT REPLACEMENT

^ Tools Required:
- J 9746-02 Hub/Rotor Support
- Or Equivalent

REMOVAL

NOTE: Raise the vehicle and support it with suitable safety stands.





Remove or disconnect the following:
1. Tire and wheel assembly.
2. Brake caliper assembly.
- Support the caliper with a piece of wire to prevent damage to the brake line.
3. Hub/Rotor assembly.
4. Wheel hub bolts with a press.
- Support the hub/rotor using J 9746-02 and the press bars.
- Do not damage the wheel mounting surface on the hub/rotor flange.

INSTALLATION

CAUTION: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion Inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.





Install or connect the following:
1. Wheel hub bolts into the hub/rotor. Place four washers and a nut on the bolt, tighten until the bolt is fully seated in the hub/rotor.
2. Hub and rotor.
3. Brake caliper.
4. Tire and wheel assembly.
- Lower the vehicle.