Disassembly of the Differential

^ Tools Required:
- J 26252 Governor Remover






REMOVE OR DISCONNECT





1. Governor bushing using J-26252.
2. The E-clips that hold the latching bracket in place on the bracket shaft.
- Move the bracket down the shaft.
3. Latching bracket bushing using J 26252.
4. Latching bracket, shaft, and spring from the case.
5. Governor assembly from the case.
6. Stop pin (9 1/2 inch only).
7. Lock screw.
8. Pinion shaft.
9. Differential pinion gears and pinion thrust washers.
- Roll the gears out of the case by rotating one of the side gears:
10. Thrust block.
11. Right side gear.
12. Right clutch plates and side thrust washer.
13. Left side gear, cam plate, and clutch plates as a assembly (cam unit).
14. Side gear thrust washer.