Center Support Bolt/Cooler Pipe Fitting Install

^ Tools Required:
- J 23093 Center Support Tool
- Or Equivalent

Important: If the center support has been reconditioned, you must use a new yellow colored center support bolt in order to maintain proper bolt torque.





1. Locate J 23093 into the center support direct clutch passage through the hole in the case.
2. Push J 23093 toward the rear servo bore seating the center support splines against the case splines.
3. Install the new center support bolt (25).
- Tighten the new center support bolt to 43 Nm (32 ft. lbs.). Do not overtighten.
4. Assure that the center support bolt head is seated to the bottom of the case.





5. Install the oil cooler pipe fitting (90) into the transmission case.
- Tighten the fitting to 35 Nm (26 ft. lbs.).