Disassembly of the Differential

^ Tools Required:
- J 22912-01 Bearing Remover

REMOVE OR DISCONNECT
1. The ring gear and differential side bearings. Refer to DISASSEMBLY OF THE REAR AXLE 10 1/2 INCH RING GEAR. Disassembly of the Rear Axle
2. Case screws.
- Set the unit on the right side case half.





3. Case halves.
A. Pry the halves apart at the yoke hole location.
B. Hold the side gear in the left side case half.
4. Governor assembly.
5. Latching bracket assembly.
6. Left side gear.
7. Left side clutch plates and guide clips.
8. Left side gear thrust washer.
9. Reaction blocks, pinion yoke, pinion gears, and pinion washers.
10. Right cam unit from the differential.
11. Right side, gear thrust washer.
- Measure and record the overall length of the gear assembly from the front of the gear to the back of the thrust sleeve including the side gear thrust washer.
12. Thrust sleeve using J 22912-01.





- Press the sleeve from the side gear.
13. Clutch plates.
14. Guide clips.
15. Wave washer.
16. Cam plate.
17. Side cam gear.