Troubleshooting Hints

1. CHECK condition of HORN MINI Fuse. If Fuse is open LOCATE and REPAIR source of overload. REPLACE Fuse.
2. CHECK that Ground G112 is clean and tight.
- CHECK for a broken (or partially broken) wire inside of the insulation which could cause a system malfunction but prove "GOOD" in a Continuity/Voltage check with a system disconnected. These Circuits may be intermittent or resistive when loaded, and if possible, should be checked by monitoring for a Voltage drop with the system operational (under load).
- CHECK for proper installation of aftermarket electronic equipment which may affect the integrity of other system (Refer to "Troubleshooting Procedures"). Diagnostic Aids