Differential Pilot Bearing Replacement

- Tools Required:
- J 34011 Pilot Bearing Remover
- J 33842 Pilot Bearing Installer

REMOVE OR DISCONNECT
1. Axle shaft (output shaft) and tube assembly.
2. Shim (20).
3. Differential pilot bearing (21). Use J 34011.

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you Install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Shim (20).
2. Differential pilot bearing (21). Use J 33842.
- Lubricate the bearing with axle lubricant.
3. Axle shaft (output shaft) and tube assembly.