Cassette Tape Player (UM6)

TO PLAY A CASSETTE (UM6)
To play a tape, the ignition lock cylinder must be in ACCESSORY or RUN position and the receiver must be turned ON.

Tapes are end-loaded into these players. Insert the tape squarely through the door, exposed tape side of the cassette facing the right. When the tape is fully inserted, the AM/FM portion of the radio will turn off and the tape will begin playing.

These tape players are built to work best with tapes that are 30 to 45 minutes long on each side. Tape longer than that are so thin, they may not work well in these players.

Once the tape is playing, use the upper and lower knobs for volume, balance, and fade just as with the radio. An arrow indicates which side of the tape is being played.

To fast forward the tape, press SEEK up. The tape will rapidly advance until you press the SEEK up push-button again.

To rewind the tape, press SEEK down. The tape will rewind rapidly until you press the SEEK down push-button again.

To go from one side of the tape to the other, press the upper knob.

To remove the tape or stop the tape and switch to radio, press the EJECT push-button.