DTC Info. Mode

Use the DTC Info mode to search for a specific type of stored Diagnostic Trouble Code (DTC) information. There are seven choices.

To get a complete description of any status, press the Enter key before pressing the desired F-key. For example, pressing enter, then a F key will display a definition of the abbreviated scan tool status.


DTC Status
This selection will display any DTCs that have not run during the current ignition cycle or have reported a test failure during this ignition up to a maximum of 33 DTC(s). DTC tests which run and pass will cause that DTC number to be removed from the scan tool screen.


Fail This Ign. (Fail This Ignition)
This selection will display all DTCs that have failed during the present ignition cycle.


History
This selection will display only DTCs that are stored to the control modules history memory. It will not display Type B DTCs that have not requested the MIL. It will display all type A and B DTCs that have the MIL and have failed within the last 40 warm-up cycles. In addition, it will display all type C DTCs that have failed within the last 40 warm-up cycles.

Last Test Fail
This selection will display only DTCs that have failed the last time the test ran. The last test may have ran during a previous ignition cycle if the a type A or B DTC is displayed. For type C DTCs, the last failure must have occurred during the current ignition cycle to appear as Last Test Fail.

MIL Request
This selection will display only DTCs that are requesting the MIL. Type C DTCs can not be displayed using this option. This selection will report type B DTCs only after the MIL has been requested.

Not run SCC (Not Run Since Code Clear)
This option will display up to 33 DTCs that have not run since DTCs were last cleared. Since any displayed DTCs have not run, their condition (passing or failing) is unknown.

Test Fail SCC (Tested Failed Since Code Clear)
This selection will display all active and history DTCs that have reported a test failure since the last time DTCs were cleared. DTCs that last failed over 40 warm-up cycles before this option is selected will not be displayed.