Troubleshooting Hints

1. CHECK GAUGES Fuse 4. If fuse is open, LOCATE and REPAIR source of overload, and REPLACE Fuse.
2. CHECK that ground G200 is clean and tight.
^ CHECK for a broken (or partially broken) wire inside of the insulation which could cause system malfunction but prove "GOOD" in continuity/voltage Check with a system disconnected. These Circuits may be intermittent or resistive when loaded, and if possible, should be checked by monitoring for a voltage drop with the system operational (under load).
^ CHECK for proper installation of aftermarket electronic equipment which may affect the integrity of other system (Refer to "Troubleshooting Procedures"). Diagnostic Aids